Storwize V7000 software versions 220.127.116.11 to 18.104.22.168 support attachment of up to 4 expansion enclosures per system. Software version 22.214.171.124 and later removes this restriction, supporting attachment of up to 9 expansion enclosures, allowing a total of 10 enclosures per system.
Storwize V7000 supports concurrent ESM firmware upgrades for those DS4000 models listed as such on the Supported Hardware List when they are running either 06.23.05.00 or later controller firmware. However, controllers running firmware levels earlier than 06.23.05.00 will not be supported for concurrent ESM upgrades. Customers in this situation, who wish to gain support for concurrent ESM upgrades, will need to first upgrade the DS4000 controller firmware level to 06.23.05.00. This action is a controller firmware upgrade, not an ESM upgrade and concurrent controller firmware upgrades are already supported in conjunction with Storwize V7000. Once the controller firmware is at 06.23.05.00 or later the ESM firmware can be upgraded concurrently.
Note: The ESM firmware upgrade must be done on one disk expansion enclosure at a time. A 10 minute delay from when one enclosure is upgraded to the start of the upgrade of another enclosure is required. Confirm via the Storage Manager applications “Recovery Guru” that the DS4000 status is in an optimal state before upgrading the next enclosure. If it is not, then do not continue ESM firmware upgrades until the problem is resolved.
Windows SAN Boot Clusters (MSCS):
It is possible to SAN Boot a Microsoft Cluster subject to the following restrictions imposed by Microsoft:
- On Windows 2003, clustered disks and boot disks can be presented on the same storage bus, but ONLY if the Storport driver is being used.
These restrictions and more are described in the Microsoft White Paper: “Microsoft Windows Clustering: Storage Area Networks“.
We have not tested, and therefore do not support, modifying the registry key as suggested on page 28 (which would allow boot disks and clustered disks on the same storage bus on Windows 2003 without the Storport driver).
- Restriction 1: ASM cannot recognise the size change of the disk when Storwize V7000 disk is resized unless the disk is removed from ASM and included again.
- Restriction 2: After an ASM disk group has successfully dropped a disk, the disk cannot be deleted from the OS. The workaround to the OS restriction is to bring down the ASM instance, delete the disk from the OS, and bring up the ASM instance again.
- Restriction 3: For RHEL4 set Oracle Clusterware ‘misscount’ parameter to a bigger one to allow SDD to do path failover first. The default miscount setting 60s is too short for SDD. We recommend to set it 90s or 120s. Command to use: crsctl set css misscount 90
Configuration limits for Storwize V7000 software version 6.1.0: